Product ID:ENAMEL GREEN 14159
MSDS Date:07/06/1988
FSC:8010
NIIN:00-616-7500
MSDS Number: BPRHZ

CON-LUX COATINGS INC

226 TALMADGE RD
EDISON, NJ 08818-0847
US

Emergency Phone: 908-287-4000

Info Phone: 908-287-4000 / FAX 908-287-9288

Cage: 60189

CON-LUX COATINGS INC

847 EDISON, NJ 08818-0847 US

Telephone: 732-287-4000

Cage: 60189

MINERAL SPIRITS (VAPOR PRESSURE 2.00 MM HG @ 20C) (LEL 1.0)

CAS: 64742-47-8

Fraction By Weight: >1%

OSHA PEL 100 PPM

TITANIUM DIOXIDE (AS NUISANCE DUST)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: >1%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

Health Hazards Acute and Chronic:ACUTE: IRRITATION OF EYES AND SKIN MAY
OCCUR WITH OVEREXPOSURE. CONTINUE BREATHING OF VAPORS MAY IRRITATE
RESPIRATORY TRACT CAUSING HEADACHE, NAUSEA AND DIZZINESS. CHRONIC:
UNKNOWN.

First Aid:INHAL: REMOVE TO FRESH AIR. RESTORE RESP, IF NEEDED. TREAT
SYMPTOMATICALLY. EYE: FLUSH IMMED W/WATER 15 MIN MINIMUM. SEE DR.
SKIN: WASH W/SOAP & WATER. REMOVE CONTAM CLOTHING. SEE DR IF IRRIT.
INGEST: DRINK 1 OR 2 GLASSES OF WATER TO DILUTE. DONT INDUCE
VOMITING. IF SPONTANEOUS VOMITING OCCURS KEEP HEAD AT/BELOW KNEE
LEVEL TO PREVENT ASPIRATION INTO LUNGS. SEE DR OR POISON CONTROL
CENTER IMMED.

Flash Point Method:TCC
Flash Point:105F,41C
Extinguishing Media:FOAM, CO2, DRY CHEMICAL, WATER MIST
Fire Fighting Procedures:SMOTHER FLAMES WITH ONE OF THE ABOVE
EXTINGUISHING MEDIA. WATER MAY BE USED TO COOL DOWN UNOPENED
CONTAINERS IN VICINITY.
Unusual Fire/Explosion Hazard:CONTAINS FLAMMABLE SOLVENT. DO NOT USE IN
AREAS WHERE SPARKS OR OPEN FLAMES ARE PRESENT.

Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES. WEAR PERSONAL
PROTECTION EQUIPMENT AND APPROVED RESPIRATOR. CONTAIN SPILL
W/ABSORBENT MATERIAL & PUT INTO VAPOR TIGHT CONTAINERS. PREVENT
MATERIAL FROM CONTACTING ANY W ATER SOURCES/SEWERS LEADING TO
SURFACE WATER.

Handling and Storage Precautions:STORE IN AREAS DESIGNED TO COMPLY WITH
ANSI/NFPA 30 FLAMMABLE AND COMBUSTIBLE LIQUIDS CODE.
Other Precautions:GROUND CNTNRS WHEN POURING LIQUIDS & POWDERS TO AVOID
STATIC CHARGE BUILD UP. DONT HANDLE TILL MFR'S SAFETY PRECAUTION
READ & UNDERSTOOD. PROVIDE ADEQUATE VENT/RESP PROTECTION TO REMOVE
DECOMP PROD DU RING WELDING/FLAME CUTTING COATED SRFCS.

Respiratory Protection:IN OUTDOOR OR OPEN AREAS, USE RESPIRATOR TO
REMOVE SOLID AIRBORNE PARTICLES OF OVER SPRAY DURING SPRAY
APPLICATION. IN RESTRICTED VENTILATION AREAS USE RESPIRATOR
DESINGED TO REMOVE COMBINATION OF PAR TICLES AND VAPOR.
Ventilation:PROVIDE SUFFICIENT VENT (VOL/PATTRN) TO KEEP AIR CONTAM
CONCENTRATION BELOW CURRENT OSHA PERMISSABLE EXPOSURE UNITS.
Protective Gloves:IMPERVIOUS TYPE REQUIRED FOR LONG/REPEAT
Eye Protection:SAFETY EYEWEAR TO PROTECT AGAINST SPLASH
Other Protective Equipment:PREVENT PROLONGED SKIN CONTACT WITH
CONTAMINATED CLOTHING.
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING OR USING
WASHROOM FACILITIES.
Supplemental Safety and Health

HCC:F4
Boiling Pt:B.P. Text:148 TO 323F
Vapor Density:> AIR
Spec Gravity:9.00 LBS/GAL
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:59.23

Stability Indicator/Materials to Avoid:YES
OXIDIZING AGENTS
Stability Condition to Avoid:EXTREME HEAT, SPARKS OR OPEN FLAMES
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE AND
LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.